[bug#71561,2/2] doc: Prepend ISC to DHCP client references.
Commit Message
This makes it clearer that this service uses the ISC's dhclient implementation
and does not support DHCP clients that have different command line interfaces.
* doc/guix.texi (Networking Setup): Prepend ISC to all DHCP client references.
Change-Id: I750ef2ffb4b23445c4a2b97aaa44eba56458f430
---
doc/guix.texi | 22 +++++++++++-----------
1 file changed, 11 insertions(+), 11 deletions(-)
Comments
Richard Sent <richard@freakingpenguin.com> writes:
> This makes it clearer that this service uses the ISC's dhclient implementation
> and does not support DHCP clients that have different command line interfaces.
>
> * doc/guix.texi (Networking Setup): Prepend ISC to all DHCP client references.
>
> Change-Id: I750ef2ffb4b23445c4a2b97aaa44eba56458f430
Reviewed-by: Maxim Cournoyer <maxim.cournoyer@gmail>
@@ -21016,27 +21016,27 @@ Networking Setup
@cindex DHCP, networking service
@defvar dhcp-client-service-type
-This is the type of services that run @var{dhcp}, a Dynamic Host Configuration
-Protocol (DHCP) client.
+This is the type of services that run @var{dhclient}, the ISC Dynamic
+Host Configuration Protocol (DHCP) client.
@end defvar
@deftp {Data Type} dhcp-client-configuration
-Data type representing the configuration of the DHCP client service.
+Data type representing the configuration of the ISC DHCP client service.
@table @asis
@item @code{package} (default: @code{isc-dhcp})
-DHCP client package to use.
+The ISC DHCP client package to use.
@item @code{interfaces} (default: @code{'all})
-Either @code{'all} or the list of interface names that the DHCP client
-should listen on---e.g., @code{'("eno1")}.
+Either @code{'all} or the list of interface names that the ISC DHCP
+client should listen on---e.g., @code{'("eno1")}.
-When set to @code{'all}, the DHCP client listens on all the available
-non-loopback interfaces that can be activated. Otherwise the DHCP
-client listens only on the specified interfaces.
+When set to @code{'all}, the ISC DHCP client listens on all the
+available non-loopback interfaces that can be activated. Otherwise the
+ISC DHCP client listens only on the specified interfaces.
@item @code{config-file} (default: @code{#f})
-The configuration file for the DHCP client.
+The configuration file for the ISC DHCP client.
@item @code{shepherd-requirement} (default: @code{'()})
@itemx @code{shepherd-provision} (default: @code{'(networking)})
@@ -21047,7 +21047,7 @@ Networking Setup
Likewise, @code{shepherd-provision} is a list of Shepherd service names
(symbols) provided by this service. You might want to change the
-default value if you intend to run several DHCP clients, only one of
+default value if you intend to run several ISC DHCP clients, only one of
which provides the @code{networking} Shepherd service.
@end table
@end deftp